btb 32365-32977 seat squeaks.fm
Transkript
btb 32365-32977 seat squeaks.fm
Service Bulletin Applies To: 06-018 September 1, 2006 2006 TSX – ALL Driver’s Seat Squeaks (Supersedes 06-018, dated May 12, 2006, to update the information marked with the black bars) SYMPTOM REPAIR PROCEDURE The driver’s seat squeaks when the driver moves in it. 1. Remove the seat track end covers: • Refer to page 20-99 in the 04-06 TSX Service Manual, or PROBABLE CAUSE The driver’s seat bracket rubs against the floor panel. • Online, enter keyword FRONT SEAT and select Front Seat Removal/Installation. 2. Loosen the four seat anchor bolts. CORRECTIVE ACTION Reposition the seat or insulate the bracket from the floor panel. 3. Push the seat forward against the rear anchor bolts and upward against the front anchor bolts, then tighten all four bolts. WARRANTY CLAIM INFORMATION In warranty: The normal warranty applies. Operation Number: 851055 Flat Rate Time: 0.4 hour Failed Part: P/N 81510-SEC-A01 Defect Code: 07403 Symptom Code: 04205 Template ID: 06-018A Skill Level: Repair Technician Push the seat upward against the front anchor bolts. Out of warranty: Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone Office. You must request consideration, and get a decision, before starting work. Push the seat forward against the rear anchor bolts. 4. Sit in the driver’s seat, and move around: • If the seat still squeaks, go to step 5. • If the squeak is gone, go to step 10. 5. Remove the four seat anchor bolts, and tilt the seat backward. © 2006 American Honda Motor Co., Inc. – All Rights Reserved BTB 32365-32977 (0609) 1 of 2 CLIENT INFORMATION: The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and you should not assume this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information applies, contact an authorized Acura automobile dealer. 6. Locate the scratch marks made by the seat frame on both sides of the floor panel (right side is shown). SEAT FRAME Locate the scratch mark made by the seat frame. 7. Cut two 15mm square pieces of carpet from underneath the driver’s seat, and use weatherstrip adhesive to glue them over the marks as shown. Cut a square of carpet... ...and glue it over the scratch mark on the floor panel. 8. Install the seat in the reverse order of removal. 9. Torque the bolts to 34 N·m (25 lb-ft). 10. Reinstall the seat track end covers. 2 of 2 06-018