WM 253 rel. 11/97 ing single phase speed controller
Transkript
WM 253 rel. 11/97 ing single phase speed controller
WM 253 rel. 11/97 ing single phase speed controller WHAT IT IS WM 253 is a manual electronic instrument designed to control speed and is particularly suitable for fan applications. HOW IT IS MADE • Housing: self extinguishing ABS with snap • Size: front panel 75x108 mm, depth 49 mm • Mount: panel mount, with fixing screw (included) • Protection: front IP50 • Connections: on screw terminal block for wires max 2.5 mm2 (one wire only per block in compliance with VDE regulations) • Regulation: from 0 to 100% through knob on front panel • Control output: 2.5 A Triac • Function type: manual control; the speed is proportional to the position of the potentiometer on the front panel • Regulation type: phase choking proportional • Consumption: 3 VA • Power supply: 230 Vac 50 Hz GENERAL DESCRIPTION WM 253 is a manual electronic instrument designed to control speed and is particularly suitable for fan applications. It is provided with a triac output to control a load up to 2.5 A. OPERATION The number of motor turns can be adjusted through a knob on the front panel, which features a grade scale from 0 to 100% of speed. The minimum speed can be set through the “min speed set” internal trimmer. At startup, the instrument supplies the load the maximum available voltage, corresponding to the maximum speed, for about 15 seconds, then it restores normal control functions according to the settings. MECHANICAL MOUNT The instrument is designed for wall mount. Drill two or more holes in correspondence of those on the instrument and hold it with the screws provided. The operating temperature range allowed for correct operation is –5 e 55 °C. Do not install the instrument in moist and/or dirty places and by heat sources. It was designed for ration in environments with common/ordinary pollution levels. ELECTRICAL CONNECTIONS WM 253 is provided with three input/output power lines for the connection to the 230 Vac, the motor (maximum load 2.5 A) and a switch (available for some versions only) to turn the load on. The instrument is provided with screw terminal blocks for wires with maximum 2.5 mm2 (one wire per terminal only, in compliance with VDE regulations). Should the charge be in direct current, it is advisable to install a protective fuse so as to prevent any damage to the instrument. TECHNICAL DATA Housing: self extinguishing ABS with snap. Size: front panel 75x108 mm, depth 49 mm. Mount: panel mount, with fixing screw (included). Protection: front IP50. Connections: on screw terminal block for wires max 2.5 mm2 (one wire only per block in compliance with VDE regulations). Operating temperature: –5…55 °C; (23…131 °F). Storage temperature: –30…75 °C; (–22…167 °F). Regulation: from 0 to 100% through knob on front panel. Control output: 2.5 A Triac. Function type: manual control; the speed is proportional to the position of the potentiometer on the front panel. Regulation type: phase choking proportional. Consumption: 3 VA. Power supply: 230 Vac 50 Hz. CONNECTIONS WM 253 1 2 3 4 5 6 POWER SUPPLY load power ON/OFF Eliwell via dell’Artigianato, 65 Zona Industriale 32010 Pieve d’Alpago (BL) Italy Telephone +39 (0)437 986111 Facsimile +39 (0)437 989066 WM 253 11/97 ing 2